Euro Machinist Square 75mm X 50mm (1-5/8 Inch) Chains Overall length: 5-1/2"

Overall length: 5-1/2"

and dimensional metalwork

The bent shank configuration allows access to areas that straight stamps cannot easily reach

Eliminates slipping of the ring during stamping

Black (Ultra Fine)

Euro Machinist Square 75mm X 50mm (1-5/8 Inch) Chains Overall length: 5-1/2"Machined from bar stock (billet) one piece stainless steel construction to DIN 875 II standards. A machinist square is the metalworker's equivalent of a woodworker's try square. Its primary purpose is measuring the accuracy of a right angle (90 degrees). To "try" a surface is to check its straightness or correspondence to an adjoining surface. A small notch has been added to the inside corner of the square to prevent small particles from accumulating