Toptul CV Joint Banding Tool (With Cutter) 225mm Promo_Bonus_Red 8 mm and hard wire

8 mm and hard wire up to 0

Part Number: 690

Drive sockets: 10

TL222 or TL221 test leads

FlukeView ® Forms installation guide

Toptul CV Joint Banding Tool (With Cutter) 225mm Promo_Bonus_Red 8 mm and hard wireOverview Item No: JEAE0423 Use to install and tighten the band it and strap style clamp on CV joint boots, power steering rack and pinion steering gear boots Bands are installed into the tool and tightened by turning the tool handle Use a 1 2" socket wrench or by hand to wind the band until sufficient tension is applied When boot clamp has been tightened to specs, the built in cutter cuts the band by flipping tool lever (at the front of the tool)